Toyota Vios NCP42 02-07 Front and Rear Absorber Dust Boot Dust cover with Bump Stopper

Toyota Vios NCP42 2002-2007

Price for one set (One Piece plus bump stop)

Harga untuk satu set (1 boot dan 1 bump stop)

Kiri kanan kena beli dua

Front Absorber dust cover with a bump stop protection kit.
Rear Absorber Plastic dust cover with an attached bump stop

Reasons you need to change every time you replace shockers
Prevents dust and moisture from damaging the piston surface and seal
Protects piston rod from corrosion due to road pollution (dust, moisture, stones impact)
Increases the life of the strut
Avoids premature oil leakage from the shock absorber
Limits the suspension travel in the compression phase which improves road handling
Saves money by increasing the life of the shock absorber and coil spring
No extra labor time if changing at the same time as the shock absorber

When should Protection Kits be changed?
Answer = Each time the shock absorbers are replaced.

Your car your choice – If a job is worth doing it’s worth doing right.

Bump Stop Installation Instructions.
-Disassemble the strut and remove the bump stop from strut.
-Slide the new bump stop and bellows over the piston rod facing the open end bellows down.
-Connect the bottom of the bellows to the top of the strut housing.(ensure that the strut is fully extended)
-Reassemble the strut in the reverse order ready for installation into the vehicle.