?Silent turbo blower 8035 brushless motor PWM speed regulation 24V30W front and rear ball bearin ??

The new 8035 inner rotor brushless motor was originally used for turbo blowers. The materials used for the motor are very good. The motor has a built-in brushless drive circuit, front and rear ball bearings. The motor supports PWM signal speed regulation and pulse signal feedback output. The motor runs very well. Quiet, the maximum no-load speed is about 2000 rpm, the maximum power is about 30W, the motor comes with a 40CM long lead, and the wiring definition picture is marked with introduction.
The nominal voltage of the motor is 24V, and the measured voltage is between 16V-24V. The motor power will be slightly smaller when the voltage decreases, but the maximum speed is still limited to about 2000 rpm, and the maximum load of 24V is almost locked. The current is about 2A, The motor supports 5V PWM signal stepless speed regulation, and the motor shaft rotates clockwise against its own running direction.
The actual measured voltage and speed of the motor are as follows, which is for reference only. If you use PWM signal to adjust the speed, you can run to a lower speed. The PWM signal board needs to be purchased separately.
The voltage is 16V, the no-load current is 0.2A, and the no-load maximum speed is 2000 rpm.
The voltage is 24V, the no-load current is 0.15A, and the no-load maximum speed is 2000 rpm.
The motor weighs 465 grams.