3:1 Ratio
Working time: 2-3 hours
Initial cure: 12-15 hours
Completely hard: 48 hours

Options (approximate weights):
Weight = Epoxy Resin(A) + Hardener(B)
2kg = 1.5kg(A) + 500g(B)
4kg = 3kg(A) + 1kg(B)

?? Our 3:1 can be cured under normal temperature and high temperature, with the features of good flowing property, low viscosity, natural defoaming, anti-yellow, high transparency, no ripple, and bright in surface.

?? Our 3:1 is specially designed for large-sized wood table casting, floral blocks, etc. You can pour 15kgs per one time with a thickness of at least 10cm or about 4inches. It is high transparency with little heat release.

?? Operation:
1 . Weigh A and B glue according to the given weight ratio into a clean container, combine the mixture by stirring the container wall clockwise, place it along for 3 to 5 minutes, and then it is now ready for use.

*Tip: Avoid lifting your stirrer when mixing. Find a momentum for a consistent stir flow and stir slow. A fast and lifted stirring produces more bubbles.

2 . To avoid any waste, take enough resin mixture for your specific project guided by its indicated working time. When the temperature is below 15°C, please heat A glue to 30°C first before mixing it with the B glue (the A glue will thicken in low temperature). A & B must be sealed after use to avoid rejection caused by moisture absorption.

3 . When the relative humidity is higher than 85%, the surface of the cured mixture will absorb moisture in the air and form a layer of white mist on the surface, so when the relative humidity is higher than 85%, it is not suitable for room temperature curing. A heat curing is advisable.

?? Caution:
The operating environment should be ventilative and should be away from fire.
Avoid eye contact. In case of contact, wash with plenty of water and get medical attention immediately.
If there is skin contact, wrap with clean cloth or paper, and wash it with water and soap.
Always keep away from children.
Most importantly, always wear protective gears when using resin.

?? Protective Garments/Gears:
Dual Filter Gas Chemical Anti-Dust Industrial Respirator Mask (to protect you from inhaling resin fumes and dust particles)
Sterile Vinyl Gloves (make sure it fits you perfectly, not loose and not too tight)
Transparent Eye Mask or Goggles (to protect you from resin fumes when it is curing and when you are sanding cured pieces)
Apron (to protect your clothes from resin)
Optional: Rubber Removable Sleeves (to protect your arms from skin contact)

Aikonic Creations promotes safe resin use. We do not support complacent and unsafe handling of resin.

?? Storage And Shelf Life
1. Store at the temperature of 25°C or cool and dry place. Avoid from sunlight, high temperature or high humidity environment.
2. Use up as soon as possible when opened. Air exposure after opening is strictly prohibited to avoid affecting the quality of the project. The shelf life is 6 months when stored properly.